Connecting The Additional Facilities - Teletek electronics MAG4 User Manual

Disable Sounders:
Press DISABLE / ENABLE button:
Press TEST / SCROLL button again:
Press TEST / SCROLL button
3 times again:
Press ENABLE / DISABLE button:
Press RESET:
To enable Sounders:
Press DISABLE / ENABLE button:
Press TEST / SCROLL button:
Press TEST / SCROLL button
3 times again:
Press ENABLE / DISABLE button:
Press RESET:

Connecting The Additional Facilities

Class Change:
Connect a 'non latching' switch to the class change terminals at the top of the
MAINBOARD.
Operation of the switch will cause the external sounders to pulse one second on followed
by one second off.
Once the panel connections and facilities have been functionally tested,
!
replace and secure the front cover of the box, remembering to connect
the earth bonding lead to the continuity terminal.
NOTE: The final closing of MAG 4 plastic box is by placing the two nuts in the
holders on the back side of the box cover. Then you have to fix the two screws
M3x15 from the set.
The final closing of MAG 4 metal box is by fixing the two secure bolts on the
front side of the pane by using the given special tool in the set.
Fire Control Panel MAG 4 - User Manual
DISABLE / ENABLE LED will flash.
Zone 1 LED will flash.
Zone 2 LED will flash.
SOUNDER FAULT / DISABLE LED will flash.
DISABLE / ENABLE LED will flash.
SOUNDER FAULT / DISABLE LED changes to
steady.
ENABLE / DISABLE LED flashes.
At this point zone the sounders are disabled.
DISABLE / ENABLE LED will flash
Zone 1 LED will flash.
Zone 2 LED will flash.
SOUNDER FAULT / DISABLE LED will be
steady.
DISABLE / ENABLE LED will flash.
SOUNDER FAULT / DISABLE LED change to
flashing.
ENABLE / DISABLE LED flashes.
At this point zone the panel has reset.
English
9