Ca62 Alarm Control Panel Inputs And Outputs - Teletek electronics CA62 Installation And Programming Manual

Hide thumbs Also See for CA62:

Table of Contents

Installation and Programming Manual - СА62 Alarm Control Panel

2.5 CA62 Alarm Control Panel Inputs and outputs CA62

Terminals description of СА62 control panel:

• AC - Power supply from 17V / 17VA mains transformer



•

- "EARTH"

• AUX - Power supply -PGM for detectors with consumption up to 1А

• +PGM - Power supply for additional devices with consumption up to 1А

• PGM1, PGM2, PGM3 - Programmable outputs

• SIReN - Siren programmable outputs (PGM4 by default)

• Z2, Z3, Z4, Z5, Z6 - Zone inputs (Z1 zone is in the keyboard))

• CoM - Common mass of the zones

• A, В - Terminals for telephone line connection

• А1, В1 - Terminals for

• ReD, BLACK - Keyboard power supply

• GReeN, YeLLoW - Interface between the panel and the keyboard

• F1 BAtt - Battery fuse 0.75А, Resettable (PTC)

• F2 AUX - Fuse for powering sensors, programmable outputs and keyboards 0.5А, Resettable (PTC)

• F3 PGM - Additional device 0.5А mains fuse, Resettable (PTC)

• BAtt - Battery cables for accumulator with parameters 12V / 7.2 Ah

• JPRG - Jumper for hardware RESET and default parameter recovery

• GPIo - Interface connector for programming

• eXPAND - Terminal for expander modules (Voice dialer)

Figure 5. CA62 control panel inputs and outputs.

Table of Contents