Table of Contents
Advertisement
10
Installation and Programming Manual - СА62 Alarm Control Panel
Must be normally closed.
Tamper switch of the key-switch.
Connecting with one balancing resistor
Figure 7. Connecting of key-switch and a fire detector to CA62 alarm control panel.
Key-switch
a) Connecting key-switch
Connecting a fire detector with one balancing resistor
Connecting a fire detector with two balancing resistors
b) Connecting a fire detector with a relay in the base
c) Connecting of two fire detectors to a doubling zone.
Must be normally closed.
Tamper switch of the key-switch.
Connecting with two balancing resistors
The programmable output
must be programmed
as
Fire Reset
and the active
status must be +12 VDC.
Fire
detector
base
The programmable output
must be programmed
as
Fire Reset
and the active
status must be +12 VDC.
Fire
detector
base
Fire
detector
base 1
Key-switch
Fire
detector
base 2
The programmable output
must be programmed
as
Fire Reset
and the active
status must be +12 VDC.
Advertisement
Table of Contents
