Husqvarna FC 350 2016 Repair Manual page 191

-
Position special tool
Crankshaft pressing tool (75029047000)
Crankshaft pressing tool insert (79029008000)
-
Position special tool @ with the heel pointing down.
I
Crankshaft pressing tool insert (79029008000)
-
Insert the crankweb with the connecting rod and bearing.
Position the second crankweb.
311610-10
-
Position special tool
I
Crankshaft pressing tool insert (77229008000)
-
Press in the upper crankweb as far as possible.
Info
The press mandrel must be positioned over the crank
pin.
-
Take the crankshaft out of the special tool and check that the
connecting rod can move freely.
-
Measure axial play
crankwebs using the special tool.
I
Feeler gauge (590290411 00)
Connecting rod - axial
play of lower conrod bear­
ing
If the measured value is less than the specification:
-
Correct it so the dimension is equal to the specified
value.
Finishing work
-
Check the crankshaft run-out at the bearing pin.
CD
on the press.
(l!!;!l p. 290)
@)
with the heel pointing down.
0
between the connecting rod and the
(!,ll p. 288)
0.20 ... 0.45 mm (0.0079
... 0.0177 in)
17 ENGINE
(!,ll p. 293)
(a p. 293)
(l!!;!l p. 291)
(l!!;!l p. 190)
189