Husqvarna FS 450 2019 Repair Manual page 197

-
Mount new connecting rod (D.
Info
Thoroughly lubricate the bearing.
310044-10
-
Position special tools @ and
Crankshaft pressing tool (75029047000)
Insert for crankshaft pressing tool (79429008000)
(8 p. 319)
-
Insert the crankweb with the connecting rod and bearing.
Position the second crankweb.
-
Position special tool
Insert for crankshaft pressing tool (78929008000)
(8 p. 317)
-
Press in the upper crankweb as far as possible.
• Info
I
The press mandrel must be positioned over the crank
pin.
-
Take the crankshaft out of the special tool and check that the
connecting rod can move freely.
-
Measure axial play
crankwebs using the special tool.
I
Feeler gauge (59029041100)
Connecting rod - end play
of lower conrod bearing
If the measured value is less than the specification:
-
Correct it so the dimension is equal to the specified
value.
310045-10
Finishing work
-
Check the crankshaft run-out at bearing pin.
@)
on the press.
(8 p. 315)
8
with the heel pointing down.
O
between the connecting rod and the
(8 p. 313)
0.20 ... 0.45 mm (0.0079 ...
0.0177 in)
(8
ENGINE 17
p. 196)
41
195