Husqvarna FS 450 2019 Repair Manual page 36

6 FORK, TRIPLE CLAMP
34
e
I
✓ The sealing lip points downward, the open side
upward.
-
Remove the special tool.
C,.
-
Push on support ring
-
Sand the edges of the slide bearings with 600 grit sand-
paper; then clean and grease the bearings.
I
Fork oil (SAE 4) (48601166S1)
-
Slide on lower slide bearing
-
Mount upper slide bearing (D.
Info
Without using a tool, pull the stack slightly apart
by hand.
-
Warm up the outside fork tube in area
slide bearings.
I Guideline
50 °c (122 °F)
-
Hold the lower slide bearing with the longer side of the
special tool.
I
Mounting tool (T14040S)
-
Slide on the outside fork tube.
-
Press the slide bearing all the way into the outside fork
tube.
-
Position the support ring.
-
Hold the seal ring with the shorter side of the special tool.
I
Mounting tool (T14040S)
-
Press the seal ring and support ring all the way into the
outside fork tube.
8.
-
Mount lock ring
✓ The lock ring engages audibly.
(il!:!I p. 305)
0 .
6)
of the lower
(8 p. 325)
(8 p. 325)