Husqvarna FS 450 2019 Repair Manual page 34

6 FORK, TRIPLE CLAMP
@)-
32
-
Mount spring pack
✓ The wide side of spring guide
down.
-
Slot end stop
✓ The cone points downward.
-
Clamp the piston rod underneath the end stop.
I Clamping stand (T14016S)
-0
-
Mount and tighten piston (D.
Guideline
Piston on piston
rod
-
Lubricate piston in area of
Grease capacity, left
cartridge
-
Clamp the air cartridge.
I Clamping stand (T14072)
-
Position the special tool @ in the cartridge.
I Mounting sleeve (T14092)
-
Push the piston rod into the air cartridge.
Info
The air cartridge must be absolutely clean on the
inside.
Do not damage the gasket when inserting the piston.
-
Remove the special tool.
-
Lubricate O-ring @ of seal ring retainer
I Lubricant (T158)
-
Mount and tighten the seal ring retainer.
Guideline
Seal ring
retainer on
cartridge
C,.
f)
is mounted facing
0
onto the piston rod.
(a p. 324)
M12x1 20 Nm (14.8 lbf ft)
@)
and inside of the cartridge.
5 g (0.18 oz) Multi-purpose
grease
(00062010051)
(a
(a p. 325)
p. 326)
(a
@).
p. 306)
(a
M35.5x0.8 40 Nm (29.5 lbf ft)
TM
®
Loctite 2701
p. 307)
TM
®
Loctite 2701