Changing The Hydraulic Clutch Fluid - Husqvarna FS 450 2019 Repair Manual

Changing the h�draulic clutch fluid
Warning
Skin irritation Brake fluid causes skin irritation.
-
Keep brake fluid out of the reach of children.
-
Wear suitable protective clothing and safety glasses.
-
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
-
Consult a doctor immediately if brake fluid has been swallowed.
-
Rinse the affected area with plenty of water in the event of contact with the skin.
-
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
-
If brake fluid spills on to your clothing, change the clothing.
Note
Environmental hazard Hazardous substances cause environmental damage.
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and clutch lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
-
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
O.
-
Remove screws
-
Take off cover@ with membrane
8
-
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1
-
On the clutch slave cylinder, remove the protection cap and
mount bleeding syringe
0.
the bleeder screw
-
Only loosen bleeder screw
the point where filling is possible.
fD.
with the appropriate hydraulic fluid.
(8 p. 310)
(8 p. 304)
8
with appropriate hose piece at
0
on the clutch slave cylinder to
CLUTCH 18
247