Using The Global Configuration Mode - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Configuring the Cisco 12008
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0102

Using the Global Configuration Mode

If you prefer not to use the interactive script of the setup facility, you can manually
configure your router using the global configuration mode. The global configuration mode
enables you to enter configuration commands on a line-by-line basis from the console
terminal.
To configure your router using the configuration mode, perform the following steps:
Step 1
Step 2
Step 3
Step 4
4-26
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
Connect a console terminal to the console port on the faceplate of the RP.
When asked if you want to enter the initial dialog, answer no. This causes the
router to enter the user EXEC mode. After a few seconds, the user EXEC mode
prompt ( >) appears:
Router
Would you like to enter the initial dialog? [yes]: no
Router>
At this prompt, enter the enable command to establish the privileged EXEC
mode:
Router> enable
Router#
Configuration changes can be made only in the privileged EXEC mode.
Note
At the privileged EXEC mode prompt, enter the config terminal command to
enter the global configuration mode:
Router# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#