Reviewing The Running Configuration Settings - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Reviewing the Running Configuration Settings

To display the running configuration settings stored in NVRAM, issue the show startup-
config command at the privileged EXEC mode prompt. This command displays output in
the following form:
Router# show startup-config
Using 1133 out of 520184 bytes
!
version 11.2
no service udp-small-servers
no service tcp-small-servers
!
hostname Router
!
enable password wilma
ip cef distributed switch
ip host biff 3.3.3.254
!
interface Ethernet0
!
interface POS3/0
!
interface POS3/1
!
interface POS3/2
!
interface POS3/3
ip address 3.3.1.1 255.255.0.0
no ip mroute-cache
ip address 2.1.1.1 255.0.0.0
no keepalive
crc 16
no cdp enable
ip address 2.1.1.2 255.0.0.0
no keepalive
crc 16
no cdp enable
ip address 2.1.1.3 255.0.0.0
no keepalive
crc 32
no cdp enable
ip address 2.1.1.4 255.0.0.0
no keepalive
crc 32
Observing System Startup and Performing a Basic Configuration 4-31
Configuring the Cisco 12008