Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 355

Figure 7-26 Removing Interface Cables from a Line Card
1
Go back to Step 2 and proceed through the cable removal procedure in a bottom
Step 5
to top direction until you have removed all of the interface cables from the line
card ports.
Step 6 Once all of the line card interface cables are removed, loosen the captive
installation screws at the top and bottom of the cable-management bracket (see
Figure 7-27).
Removing and Replacing the Cable Management System
2 3
Maintaining the Cisco 12008 7-75