Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 199

2 four-port OC3 POS controllers (8 POS).
5 OC12 POS controllers (5 POS).
1 Ethernet/IEEE 802.3 interface(s)
13 Packet over Sonet network interface(s)
507K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Notice: NVRAM invalid, possibly due to write erase.
The first two sections of the above configuration script (containing the
Note
banner screen and the installed hardware listing) appear only at initial system
startup. On subsequent uses of the setup command facility, the setup script
begins with the following system configuration dialog.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes/no]: yes
Enter yes when queried if you want to continue with the configuration dialog.
The examples in this section represent a continuation of the console
Note
display for the setup facility or the setup command.
Enter yes when asked if you wish to enter the initial configuration dialog and if
Step 3
you wish to see the current interface summary:
Would you like to enter the initial configuration dialog? [yes]:
yes
First, would you like to see the current interface summary? [yes]:
yes
Observing System Startup and Performing a Basic Configuration 4-15
Configuring the Cisco 12008