Upgrading Memory On The Rp - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Upgrading Memory on the RP

If the system fails to restart properly after several attempts and you are unable to resolve
the problem, contact your Cisco service representative for assistance. Before calling,
however, make note of any console error messages, unusual LED states, or other system
indications or behaviors that might help to resolve the problem.
The time that the system requires to initialize may vary with different router configurations
and memory configurations. For example, a router with a larger complement of memory
might take longer to boot.
Upgrading Memory on the RP
The Cisco 12000 Series Gigabit Switch Router Memory Replacement Instructions (78-
4338-xx), which is available on-line and on the Cisco CDROM, contains the latest
information about memory requirements and replacing memory on the Cisco 12000 series
RPs and line cards. Refer to that document before replacing or adding memory to your RP
or line card.
You can find the Cisco 12000 Series Gigabit Switch Router Memory replacement
instructions at Cisco.com:
http://www.cisco.com/univercd/cc/td/doc/product/core/cis12012/bfrcfig/4338bmem.htm
7-90
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide