Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 308

Adding, Removing, or Replacing a DC-Input Power Supply
Figure 7-9
Alarm
terminal
block
Normal state of
circuit breaker
Step 15
Step 16
7-28
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
Connecting Leads to the Circuit Breaker Alarm Terminal Block
COM
NC
NO
Equivalent circuit
inside power supply
COM
NC
NO
Reinstall the plastic safety shield (see Figure 7-7) on the power supply faceplate
by taking the following actions:
(a) Seat the shield over the standoffs on the power supply faceplate.
(b) Move the shield to the left and obliquely downward so that it registers
properly on the three standoffs on the power supply faceplate.
(c) Tighten the knurled thumbscrew on the bottom left standoff to secure the
shield to the power supply faceplate.
Remove the tape from the main circuit breaker supplying source power to the
new power supply (see Step 1).
Klaxon
Light
Normally open; if circuit breaker
inside power supply is tripped due
to overcurrent condition, Klaxon
would sound and light would flash
48 VDC
1A max