Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 219

Table 4-3 Definition of Bits in the Software Configuration Register (Continued)
Bit Number Hexadecimal Value
11 and 12 0x0800 to 0x1000
13 0x2000
14 0x4000
15 0x8000
1. OEM stands for original equipment manufacturer.
Table 4-4 specifies the content of the boot field, which defines a source for booting the
default Cisco IOS software image required to run the router. The content of the boot field
is specified as a binary number.
Table 4-4 Definition of Bits in Boot Field of Software Configuration Register
Boot Field Bits Meaning
00 On power up, the system remains at the ROM monitor prompt (
awaiting a user command to boot the system manually.
01 On power up, the system automatically boots the first system image found in
the onboard Flash memory single inline memory module (SIMM) on the RP.
02 to 0F On power up, the system boots automatically from a default Cisco IOS
software image stored on a TFTP server in the network. For this setting, it is
assumed that the Ethernet port on the RP is configured and operational. A
default Cisco IOS software image is typically kept on a Cisco "Help Desk"
server in the network for ready access by anyone needing a boot image. This
setting also enables boot system commands that override the default
filename.
Observing System Startup and Performing a Basic Configuration 4-35
Performing Other Configuration Tasks
Meaning/Function
Defines the console baud rate (the default setting is
9600 baud).
Boots the default Flash memory software if the
network boot fails.
IP broadcasts do not have network numbers.
Enables diagnostic messages and ignores the
contents of NVRAM.
),
rommon>