Replacing An Existing Ac-Input Power Supply - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Step 8
Step 9
If you intend to return the removed power supply to the factory for repair or replacement,
repackage the unit properly for return shipment using the original packing materials, if
available.

Replacing an Existing AC-Input Power Supply

In the following procedure, it is assumed that you will replace an existing power supply in
a router that is configured with two (redundant) AC-input power supplies.
In this configuration, the router's online insertion and removal (OIR) capability enables you
to replace one of the power supplies without removing power from the other. Thus, the
router can remain fully operational during the power supply replacement procedure.
To replace one of the AC-input power supplies in a redundant power supply configuration,
perform the following steps:
Step 1
Step 2
Step 3
Step 4
Adding, Removing, or Replacing an AC-Input Power Supply
Place your free hand beneath the power supply to support its weight and
withdraw the unit completely from the bay.
Set the power supply aside, pending further disposition.
On the power supply to be replaced, set the rotary power switch to the standby
(OFF) position.
Turning the power supply switch counterclockwise to the standby (OFF)
Note
position also releases the mechanical interlock (latching mechanism) that
secures the power supply within in the bay.
Locate and turn off the source AC circuit breaker that is currently servicing the
AC-input power supply.
Tape the circuit breaker handle in the OFF position as an added safety
precaution.
Using a 1/4-inch flat-blade screwdriver, loosen the captive installation screw on
the power supply faceplate.
Maintaining the Cisco 12008 7-13