Performing Other Configuration Tasks; Configuring The Software Configuration Register - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Performing Other Configuration Tasks

This section presents procedures for performing the following additional configuration
tasks:
•

Configuring the Software Configuration Register

•
Recovering a Lost Password
•
Using Flash Memory Cards in the RP
Configuring the Software Configuration Register
The software configuration register is a 16-bit register in NVRAM that you use to define
specific system parameters.You can set or change the contents of this register to accomplish
the following tasks:
•
Define boot sources for the default Cisco IOS software, assigning them in the following
order of precedence:
— Flash memory card inserted in PCMCIA slot 0
— TFTP server in the network
— Flash memory SIMM (NVRAM) on the RP
— Boot image stored within the operating environment, which you access by means
•
Define a default boot filename.
•
Enable or disable the Break function.
•
Control broadcast addresses.
•
Set the console terminal baud rate.
•
Recover a lost password.
of an appropriate form of the boot command issued at the ROM monitor prompt
( )
rommon>
Observing System Startup and Performing a Basic Configuration 4-33
Performing Other Configuration Tasks