Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 229

Configuration Summary
enabled are:
console baud: 9600
boot: image specified by the boot system command
or default to: cisco2-grp
do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
Initialize the router by entering the initialize command at the ROM monitor
Step 7
prompt:
rommon 1> i
The router power cycles, the software configuration register is set to ignore the
configuration file, and the router boots the system image and displays the system
configuration dialog:
--- System Configuration Dialog ---
.
.
.
Enter no in response to the system configuration dialog prompts until the
Step 8
following instruction is displayed:
Press RETURN to get started!
Press Return.
Step 9
After the interface configuration information is displayed, the user EXEC mode
prompt appears:
Router>
Step 10 Issue the enable command at the user EXEC mode prompt to enter the
privileged EXEC mode:
Router> enable
Router#
Observing System Startup and Performing a Basic Configuration 4-45
Performing Other Configuration Tasks