Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 245

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCC
Router#
In this example, the exclamation points (!!!) appear as the file is being
Note
copied. The "C" characters signify the calculation of the CRC. The CRC verifies
that the file has been copied correctly.
To further verify that the configuration file was copied correctly to the Flash
Step 3
memory card inserted in slot 0, issue the directory command:
Router# dir slot0:
-#- -length- -----date/time------ name
1 5200084
3 1215
4 6176844
5 1186
9197156 bytes available (11381148 bytes used)
Router#
Copying a Configuration File from DRAM to a Flash Memory Card
To copy a configuration file from DRAM to a Flash memory card, perform the following
steps:
Issue the command for copying a configuration file from DRAM to a Flash
Step 1
memory card. The command takes the following form:
copy startup-config [slot0: | slot1: ]:filename
where:
copy startup-config specifies the source file to be copied from DRAM.
[slot0: | slot1: ]:filename specifies the destination of the configuration file to be
copied (the Flash memory card inserted in either slot 0 or slot 1) and its name.
Observing System Startup and Performing a Basic Configuration 4-61
May 10 1997 19:24:12 gsr-p-mz.112-8
May 10 1997 20:30:52 myfile1
May 10 1997 23:04:10 gsr-p-mz.112-8.1
May 10 1997 16:56:50 myfile2
Performing Other Configuration Tasks