Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 208

Configuring the Cisco 12008
Step 5
On completion of this procedure, you have manually configured the global system
parameters and the network interface parameters using the setup facility or the setup
command. Your Ethernet, POS, and ATM interfaces are now available for limited use.
If you wish to modify the currently saved configuration information (after you complete the
preceding procedure), issue the setup command at the privileged EXEC mode prompt
(
Router#
To perform more complex configuration tasks, you can enter the configure command at the
privileged EXEC mode prompt (
[
Router(config)#
Configuration Mode."
4-24
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
When you have completed entering the configuration information for all of the
installed line cards, the following configuration query is displayed:
Use this configuration? [yes/no]:
At this point, you should visually verify all of the configuration parameters
displayed on your console terminal.
Answer yes if you want to save the running configuration file to NVRAM and
display the following additional output:
Use this configuration? [yes/no]: yes
[OK]
Use the enabled mode 'configure' command to modify this
configuration.
Press RETURN to get started!
After you press Return, the system reverts to the user EXEC prompt:
Router>
Answer no to the configuration query to return to the privileged EXEC mode
prompt ( ). You must reissue the setup command and enter the
Router#
appropriate RP and line card configuration information.
) at any time.
]. This mode is described in the section entitled "Using the Global
), which establishes the global configuration mode
Router#