Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 353

Figure 7-25
2
Installation screws
ESD socket
Step 5
Step 6
Step 7
Removing and Replacing the Cable Management System
Installing a Cable Management Tray
1
3
Install the end cap onto the chassis by pushing it onto the chassis fasteners (see
Figure 7-25, part 2).
Secure the cable-management tray in the recess with the remaining two
installation screws that you set aside in the previous procedure entitled
"Removing a Cable-Management Tray."
Install the top trim piece onto the chassis by pushing it onto the chassis fasteners
(see Figure 7-25, part 3).
Maintaining the Cisco 12008 7-73