Installing Baseplate-Mounted Accessories; Installing Slide-Mounted Accessories - Thermo Scientific Nicolet iS10 Using Manual

4.—Place the screws that came with the sample compartment extension kit into the holes in
the sample compartment extension, and then use the 4-in1 tool with a Philips bit installed
to tighten the screws. (The screws should be just finger-tight.)
5.—Install the sample compartment cover.
You are now ready to install baseplate-mounted accessories.
Note: Please see "Installing a sample" and "Adjusting sample height" for additional
information about using baseplate-mounted accessories.

Installing baseplate-mounted accessories

For information about installing accessories that are mounted on a baseplate, please refer to
the procedure for installing a baseplate. For additional information about using baseplate-
mounted accessories, see "Installing a sample" and "Adjusting sample height."

Installing slide-mounted accessories

The sample holder is designed to accommodate slide-mounted accessories (such as a variable
angle ATR) as well as thin film samples and optical filters. To install a slide-mounted
accessory:
1.—Slide the accessory into one pair of slots in the standard sample holder.
18 Using Your Nicolet iS10 Spectrometer Thermo Fisher Scientific