Table of Contents
Advertisement
2.—If you used a 1/4 inch male fitting, proceed to the next step.
If you used a 3/8 inch female fitting on the purge gas source, install the 3/8 inch to 1/4
inch reducing nipple that was included with your purge kit. Wrap the reducing nipple with
Teflon pipe tape before you install it, and use an 11/16 inch open-ended wrench to tighten
the connection.
3.—Wrap the reducing nipple or the 1/4 inch male fitting with Teflon pipe tape, and then
install the pressure coupling. Use a 3/4 inch open-ended wrench to tighten the connection.
Thermo Fisher Scientific
Using Your Nicolet iS10 Spectrometer
15
Advertisement
Table of Contents
