Operation; Turning The Power On And Off; Installing A Smart Accessory; Collecting Data With The Instrument - Thermo Scientific Nicolet iS10 Using Manual

Operation

Turning the power on and off

To turn the system power on or off, press the power switch on the power supply.

Installing a Smart Accessory

To install a Smart Accessory™ in the sample compartment, lower the accessory into the
sample compartment and press gently downward until the accessory locks in place. Then
rotate the stabilizer arm (located on the top of the instrument at the back edge of the sample
compartment) so that it holds down the accessory.
Note: If you want to remove a Smart Accessory, simply reverse the steps in this procedure.
When you are not using an accessory, store it in a dust-free environment like a cabinet or box.
Note: For information about installing other kinds of accessories, see "Installing other
accessories".

Collecting data with the instrument

For information about collecting data with your instrument, please see the getting started
manual that came with the instrument.

Collecting data with the module

You must use OMNIC to collect data. OMNIC can be started by using the OMNIC shortcut on
your system desktop. For additional information, please see the OMNIC help (available
through the Help menu in OMNIC) or the printed documentation that came with the system
microscope or spectrometer.
Thermo Fisher Scientific Using Your Nicolet iS10 Spectrometer 9