Management Ethernet Port Cable Connection; Connecting Power To Cisco Asr 1002 Router - Cisco ASR 1000 Series Installation And Configuration Manual

Chapter 6 Cisco ASR 1002 Router Overview and Installation

Management Ethernet Port Cable Connection

To comply with Class A emissions requirements, a shielded Ethernet cable must be used for the
Caution
connection.
To use the Management Ethernet interface on the router, perform the following steps:
Step 1 Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see
Figure 6-19
1 MGMT - management port and cable
Insert the other end of the RJ-45 cable to your management device or network.
Step 2

Connecting Power to Cisco ASR 1002 Router

Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Warning When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
OL-13208-03
Cisco ASR 1002 Router Embedded ASR1000-RP1 Management Port Connector
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
MT S
CA RR IER
BO OT
QE 3
QE 2
QE 1
QE 0
ST AT
A S R 10 02
m in
st at
m aj
pw r
cr it
Connecting Power to Cisco ASR 1002 Router
Figure 6-19).
1
T
PW R STA
CO N
AU X
MG MT
LIN K
3-P OS
SPA -4X OC
6-27