Replacing The Cisco Asr 1000 Series Rp1 Internal Hard Drive - Cisco ASR 1000 Series Installation And Configuration Manual

Removing and Replacing the Cisco ASR 1000 Series RP1 Internal Hard Drive
This completes the procedure for disconnecting the Cisco ASR 1000 Series RP1 internal hard drive.

Replacing the Cisco ASR 1000 Series RP1 Internal Hard Drive

To replace the Cisco ASR 1000 Series RP1 internal hard drive and insert the Cisco ASR 1000 Series
Route Processor 1 into the Cisco ASR 1000 Series Router, follow these steps:
On the Cisco ASR 1000 Series RP1, carefully align the new hard drive unit with its screw fastener to the
Step 1
base screw on the bottom of the module.
Reconnect the two cables to the rear of the hard drive. These are keyed for easy connection.
Step 2
Figure 8-5
1
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
8-8
Cisco ASR 1000 Series RP1 Internal Hard Drive and Module Base
Hard drive module fastener
Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units
1
2
2 Carrier mating fastener
OL-13208-03