Connecting Ac-Input Power To Cisco Asr 1004 Router - Cisco ASR 1000 Series Installation And Configuration Manual

Chapter 5 Cisco ASR 1004 Router Overview and Installation
This section provides the procedures for connecting AC-input and DC-input power to your
Cisco ASR 1004 Router.
The DC power supply for the Cisco ASR 1006, ASR 1004, and ASR 1002 routers operate at individual
specifications.
Table 5-2
Cisco ASR 1000
Series Router DC
Power Supply System Input Rating (Amps)
Cisco ASR 1006 40
Cisco ASR 1004 24
Cisco ASR 1002 16
For example, the Cisco ASR 1002 Router DC power supply, with 16 Amp input rating must use an AWG #12 gauge wire for a 20Amp circuit breaker and
an AWG #10 gauge wire for a 30Amp circuit breaker.
All Cisco ASR 1000 Series Router AC power supplies require a 20 AMP circuit breaker.
Note
Detailed instructions for removing and replacing the Cisco ASR1000 Series AC and DC power supplies
Note
are in

Connecting AC-Input Power to Cisco ASR 1004 Router

Follow these steps to connect an AC-input power supply to the Cisco 1004 chassis:
Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
Step 1
Tighten the captive screws.
Step 2
Insert the AC power cable into the power inlet.
Step 3
Plug the power supply cable into the power source.
Step 4
Note
OL-13208-03
Table 5-2 shows the common input ranges and circuit breaker requirements.
Cisco ASR 1000 Series Router DC Power Supply System Input Requirements
Chapter 8, "Replacing Cisco ASR 1000 Series Routers Field-Replaceable
For additional AC power cable strain relief, secure the cable to the power supply handle by
inserting a nylon cable tie through the hole in the handle and around the cable.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
Circuit Breaker Amps
Minimum Maximum
Always 50
30 40
20 30
Connecting Power to Cisco ASR 1004 Router
AWG # Wire
Minimum Maximum
Always AWG #6 wire
10 8
12 10
Units.".
5-23