Cisco ASR 1000 Series Installation And Configuration Manual page 44

Cisco ASR 1000 Series Route Processor
Table 2-1
Table 2-1
LED Label
PWR
STAT
ACTV
STBY
CRIT
MAJ
MIN
DISK HD
DISK USB External USB Flash
DISK BF
CARRIER
LINK
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
2-4
lists the Cisco ASR 1000 Series Route Processor LEDs and behaviors.
Cisco ASR 1000 Series Route Processor LEDs
LED Color —State
Power Solid green
Off
System status Solid green
Yellow
Red
Active Green
Standby Yellow
Critical Solid Red
Major Solid Red
Minor Amber
Internal hard drive Flashing Green
LED
Off
Flashing Green
LED Off
Internal USB Flashing Green
bootflash LED
Off
LED Off
Solid Green
Amber
10/100/1000 RJ-45 Solid Green
Interface LED
Flashing Green
Off
Chapter 2 Cisco ASR 1000 Series Routers Components
Behavior Description
All power requirements are within
specification
Off, the router is in standby mode.
Cisco IOS software has successfully
booted.
BootROM has successfully loaded.
System failure or during boot process.
Lit when the Cisco ASR 1000 Series RP1
is active.
Lit when the Cisco ASR1000 Series RP1 is
the standby processor.
Critical alarm indicator or during boot
process. An example: the ambient air tem-
perature is above 60ºC and will begin
shutdown in 5 minutes.
Major alarm indicator. For example:
Ambient air temperature is beyond short
term operating range of 55ºC. System will
shut down above 60ºC.
Minor alarm indicator. Ambient air tem-
perature is beyond normal operating range
of 40ºC. For example: if the RP software
determines that an unknown card has been
installed or if the card has failed, the card
can power it off or set a minor alarm.
Activity indicator.
No activity.
Activity indicator.
No activity.
Activity indicator.
No activity.
Out of service or not configured.
In frame and working properly.
Fault or loop condition exists.
Link with no activity.
Link with Activity.
No link.
OL-13208-03