Cisco ASR 1000 Series Installation And Configuration Manual page 146

Attaching a Chassis Ground Connection
Step 4 Attach the grounding lug with the wire on the left to avoid having the grounding wire overlapping the
power supply.
Figure 5-12
1
Locate the chassis ground connector on the side of your chassis.
Step 5
Insert the two screws through the holes in the grounding lug as shown in
Step 6
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held
Step 7
firmly to the chassis. Do not overtighten the screws.
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure
Step 8
an adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. To continue on, go to
the Cable-Management Bracket, page
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
5-18
Figure 5-12 shows how to attach the grounding screws.
Attaching a Grounding Lug to the Chassis Ground Connector
2
1
Chassis ground connector
Chapter 5 Cisco ASR 1004 Router Overview and Installation
2 Ground symbol
5-19.
Figure 5-12.
Attaching
OL-13208-03