Connecting Network Management And Signal System Cables - Cisco ASR 1000 Series Installation And Configuration Manual

Connecting Network Management and Signal System Cables

Step 2 Run the cable up and through the cable-management bracket and connect the other end of the RJ-45
cable to the RJ-45 adapter
Figure 5-22
1
Step 3 Connect the adapter to your video terminal to complete the cable connection.
Power on your video terminal.
Step 4
Configure your video terminal to match the following default console port settings:
Step 5
•
•
•
•
•
Go to the
Step 6
continue the installation.

Connecting Network Management and Signal System Cables

The Cisco ASR 1004 Router has connections to both the internal Ethernet management network and the
external data network.
•
•
Keep the following guidelines in mind when connecting external cables to the Cisco ASR 1004 Router:
•
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
5-30
(Figure
Cisco ASR 1004 Router Cable-Management Bracket
2
BITS port connection
9600 baud
8 data bits
No parity generation or checking
1 stop bit
No flow control
"Connecting Network Management and Signal System Cables" section on page 5-30
The internal Ethernet management network connections are made through an Ethernet port on the
front panel of the Cisco ASR 1000 Series Route Processor 1.
The external data network connections are made through front panel ports on several types of SPAs.
To reduce the chance of interference, avoid crossing high-power lines with any interface cables.
Chapter 5
5-22).
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
SPA -4XO C3-P OS
LINK
RNET
HD CAR RIER MGM T ETHE
BITS
USB
CRI T
DF
MAJ
ACT V
PW R DISK
1
MIN
STB Y 0
STA T
RP 1
AS R10 00-
1
2 Cable-management bracket U feature device
Cisco ASR 1004 Router Overview and Installation
SPA -4XO C3-P OS
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
AUX
CON
2
to
OL-13208-03