Cisco ASR 1000 Series Installation And Configuration Manual page 70

Cisco ASR 1000 Series Router Power Supplies
Figure 2-16
1
2
3
4
Table 2-18
Table 2-18 Cisco ASR 1002 Router Power Supply LEDs
LED Label LED
INPUT OK Power supply activity
FAN OK Bi-color LED indicates
fan status
OUTPUT FAIL Power supply activity
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
2-30
Cisco ASR 1002 Router AC Power Supply
1 2 3 4
OUTPUT INPUT FAN
FAIL OK OK
0
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
8
Chassis ESD socket
AC power supply slot number 0
AC power supply On (I) /Off (O) switch
AC power supply LEDs
describes the AC power supply LEDs on the Cisco ASR 1002 Router.
Color
Green
None
Green
Red
Red
Chapter 2
5 6
5 AC power supply fan
6 AC power supply captive installation screw
7
AC power supply slot number 1
8
AC power inlet
Description
LED illuminates green to signal that the power supply
input voltage is greater than 85V.
If LED is not illuminated, then the input voltage is less
than 70V or the power supply is turned off. For an AC
input voltage between 70V and 85V, the INPUT OK LED
can be either on, off, or flashing
LED illuminates green when all fans are operational.
The LED illuminates red when a fan failure is detected.
LED is red and turned off to signal that the DC output
voltages are within the normal operating range; output
voltage between the minimum and maximum limits will
not create an output fail alarm, and output voltages below
the minimum or above the maximum will create an output
fail alarm.
Cisco ASR 1000 Series Routers Components
OUTPUT INPUT FAN
FAIL OK OK
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
OL-13208-03
1
7