Four-Post Rack Installation - Cisco ASR 1000 Series Installation And Configuration Manual

Chapter 6 Cisco ASR 1002 Router Overview and Installation
Figure 6-12
1
Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on
Step 2
both sides of the rack.
Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the
Step 3
holes on the rack or mounting strip.
For each bracket, insert and tighten two screws to the rack on both sides.
Step 4
This completes the procedure for installing the chassis in a two-post rack. Proceed to the
Chassis Ground Connection" section on page 6-23

Four-Post Rack Installation

The Cisco ASR 1002 Router can be flush-mounted in a 19-inch equipment rack using the rack-mounting
kit provided with your system. The Cisco ASR 1002 Router can be mounted into the rack using two
recommended methods:
•
•
When handling the chassis, always follow proper lifting practices, see
3-20.
Note Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches
(48.26 cm). The height of the chassis is 3.47 inches (8.8 cm). Airflow through the chassis is from front
to back.
OL-13208-03
Attaching the Rear Rack-Mount Brackets to the Cisco ASR 1002 Router
Rack equipment rail
Installing the chassis in an existing rack with equipment.
Installing an empty chassis in a rack with no equipment installed.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
Installing the Cisco ASR 1002 Router in a Rack
AS R 10 02
min
stat
maj
pwr
crit
2
1
2
Rack-mount bracket ear and holes
to continue the installation.
SPA-4 XOC3 -POS
SPA-4 XOC3 -POS
-POS
SPA-4 XOC3
"Attaching a
Chassis-Lifting Guidelines, page
6-19