Console And Auxiliary Port Cable Connections; Management Ethernet Port Cable Connection - Cisco Router ASR 1006 Hardware Installation Manual

Step 8 Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate
chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the
on page 12 for information on attaching cables.
4
Connect the Router to the Network
This section provides information about cables and ports and attaching the router to the network.
• Console and Auxiliary Port Cable Connections, page 12
Management Ethernet Port Cable Connection, page 12
•
Connect the Shared Port Adapter Cables, page 13
•
Install the Cables in the Cable-Management Bracket, page 13
•

Console and Auxiliary Port Cable Connections

This section describes how to attach a cable to the console or auxiliary ports on the Cisco ASR 1006 Router.
ASR 1006 Router uses RJ-45 ports for both the auxiliary port and console port to attach a modem or console terminal.
The console DCE-mode port connects a console terminal and a DTE-mode auxiliary port connects a modem or other DCE device
to your router.
Note Both the console and the auxiliary ports are asynchronous serial ports; any devices connected to these ports must be
capable of asynchronous transmission. (Asynchronous is the most common type of serial device; for example, most
modems are asynchronous devices.)
Before connecting a terminal to the console port, configure the terminal to match the router console port as follows:
Step 1
9600 baud, 8 data bits, no parity, 1 stop bits. See
After you establish normal router operation, you can disconnect the terminal.
Step 2
For console and auxiliary port pinouts, see
Note
Guide.

Management Ethernet Port Cable Connection

Before you can use the console interface on the router using a terminal or PC, you must perform the following steps:
Configure your terminal emulation software with the following settings: 9600 bits per second (bps), 8 data bits, No
Step 1
parity, one stop bit, No flow control.
For information about how to change the default settings to meet the requirements of your terminal or host, refer
Note
to the Cisco IOS Terminal Services Configuration Guide.
Connect a terminal or PC to the console port using the cable and adapters provided in the accessory kit that shipped
Step 2
with your Cisco ASR 1006 Router:
Place the console port mode switch in the in position (factory default).
–
12
Figure 8 for console and auxiliary port connector location.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation
"Connect the Router to the Network" section
The Cisco