Cisco ASR 1000 Series Installation And Configuration Manual page 184

Attaching a Chassis Ground Connection
Figure 6-15
1 F0 with ASR1000-ESP5 or ESP10.
2
R0 slot with embedded ASR1000-RP1 and
embedded ASR1000-SIP10.
To attach the grounding lug to the chassis ground connector on your chassis, follow these steps:
Use the wire stripper to strip one end of the AWG #6 wire approximately 0.75 inches (19.05 mm).
Step 1
Step 2 Insert the AWG #6 wire into the wire receptacle on the grounding lug. Use the manufacturers's
recommended crimping tool to carefully crimp the wire receptacle around the wire; this step is required
to ensure a proper mechanical connection.
Figure 6-16
1
2
Step 3 Attach the grounding lug with the wire on the left to avoid having the grounding wire overlapping the
power supply.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
6-24
Cisco ASR 1002 Router Chassis Ground Lug Location and Side Panel Door
4
3
Attaching a Grounding Lug to the Chassis Ground Connector
Chassis ground connector holes
Grounding lug
Chapter 6 Cisco ASR 1002 Router Overview and Installation
LINK
MTS
CARR IER
BOOT
QE3
QE2
QE1
QE0
STAT
AS R 100 2
min
stat
maj
pwr
crit
3 The eUSB panel door on the side of the Cisco
ASR 1002 Router must not be opened. If there
is a problem with eUSB flash card, the chassis
should be returned.
4
Cisco ASR 1002 Router ground stud location.
4 2
3 Ground lug screws
4 Ground wire
1
2
POS
SPA-4 XOC3-
PWR STAT
CON
AUX
MGMT
POS
SPA-4 XOC3-
POS
SPA-4 XOC3-
3
1
OL-13208-03