Cisco ASR 1000 Series Installation And Configuration Manual page 212

Removing and Replacing the Cisco ASR 1000 Series RP1 Internal Hard Drive
Figure 8-2
Figure 8-2
Step 6 Using a # 2 Phillips screwdriver or a flat head screwdriver, loosen the screw fasteners and remove the
cover as shown in
Step 7 On the hard drive, unscrew the captive screw fastener.
Note
Carefully disconnect the cables at the rear of the hard drive. These cables are tie-wrapped in to prevent
Step 8
them from disconnecting from the Cisco ASR 1000 Series RP1 itself. If the cables are not damaged,
leave the cables connected to the Cisco ASR 1000 Series Route Processor 1 with the tie wrap in place.
Remove the old hard drive.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
8-6
displays the Cisco ASR 1000 Series RP1 module with the hard drive cover removed.
Cisco ASR 1000 Series RP1 Module Hard Drive Cover and Screw Fastener
Figure 8-2.
Inspect the existing cables and replace them only if they are damaged. If you do not need to
replace them, leave the connection to the Cisco ASR 1000 Series Route Processor 1 in place and
only remove the connection to the internal hard drive.
Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units
2
1
OL-13208-03