Four-Post Rack Installation - Cisco ASR 1004 Install Manual

Chapter 7 Cisco ASR 1004 Router Overview and Installation
Figure 7-10
Figure 7-10
1
Step 2 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on
both sides of the rack.
Step 3 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the
holes on the rack or mounting strip.
Step 4 For each bracket, insert and tighten two screws to the rack on both sides.
This completes the procedure for installing the chassis on a two-post rack. Proceed to the
Chassis Ground Connection" section on page 7-17

Four-Post Rack Installation

The Cisco ASR 1004 Router can be flush-mounted in a 19-inch equipment rack using the rack-mounting
kit provided with your system. The Cisco ASR 1004 Router can be mounted into the rack using two
recommended methods:
•
•
OL-13208-09
shows where to attach the chassis rack-mount brackets to the equipment rack.
Attaching the Rear Rack-Mount Brackets to the Cisco ASR 1004 Router
Rack-mount bracket ear and holes
Installing the chassis in an existing rack with equipment.
Installing an empty chassis in a rack with no equipment installed.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Installing the Cisco ASR 1004 Router in a Rack
HD
USB
CRIT
DF
MAJ
ACTV
DISK
PWR
1
MIN 0
STBY
STAT
1
ASR 1000 -RP
1
2
2 Rack equipment rail
to continue the installation.
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
SPA-4 XOC3 -POS SPA-4 XOC3 -POS
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
AUX
LINK CON
NET
CARR IER MGMT ETHER
BITS
"Attaching a
7-15