Four-Post Rack Installation - Cisco ASR 1001-HX Hardware Installation Manual

Installing the Router
Figure 26: Cisco ASR 1002-HX Router Installed on a Two-Post Equipment Rack
1
What to Do Next
This completes the procedure for installing the chassis on a two-post rack. Proceed to the
Ground

Four-Post Rack Installation

Procedure
Step 1 (Optional) Install a shelf in the rack to support the Cisco ASR 1001-HX Router or Cisco ASR 1002-HX
Router. If you use a shelf, it helps support the chassis while you secure it to the rack.
Note
Step 2 With two people, lift the chassis into position between the rack posts.
Step 3 Position the chassis until the rack-mounting flanges are flush against the mounting rails on the rack.
Rack equipment rail
Connection" section to continue the installation.
If you are using a shelf, place the chassis on the shelf and slightly raise the front of the chassis to
align the mounting bracket holes with the rack post holes while allowing the bottom of the chassis
to rest on the shelf.
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
Four-Post Rack Installation
2 Rack mount bracket ear and screws
"Attaching a Chassis
59