Table of Contents
Advertisement
4.3.9.2. Signal strength of wireless detectors
The function allows to check signal strength of wireless detectrors.
LEDs 1 – 16 indicate line with wireless detectors.
Enter the line number and press
from selected wireless detectors. No lighted LEDs indicates no signal.
1 LED – 12% signal strength
2 LEDs – 25% signal strength
3 LEDs – 37% signal strength
4 LEDs – 50% signal strength
5 LEDs – 62% signal strength
6 LEDs – 75% signal strength
7 LEDs – 88% signal strength
8 LEDs – 100% signal strength
At the same time, the keypad indicate the signal strength by a sound. 1 beep means 25%
signal strength, 2 beeps means 50% signal strength, 3 beeps means 75% signal strength, 4
beeps means 100% signal strength.
To return to line selecting menu press
To exit the function press
4.3.9.3. Delete all wireless sensors
To remove all wireless sensors from the system, enter the following function:
After entering the function PROG LED is blinking, the other LEDs are off. Pressing
deletes all wireless sensors, generating 3 beeps and exit the function. If you press
will exit the function and detectors will not be erased.
4.3.10. Remote controllers configuration
4.3.10.1. Remote controllers configuration
Remote controllers can be configured using complex service functions, after activation of
which, all the parameters related to the relevant remote control can be given subsequently
or in a form of series of service functions that configure one remote control related
parameter. Codes of the remote control configuration functions are defined as per the
following pattern:
Where:
XX – determines the number of remote control
CPX220NWB ALARM CONTROL UNIT – INSTALLER MANUAL
to confirm. LEDs 1 – 8 will display signal strength
or
(or
, if no key has been selected).
<XX> <Y>
.
key
key
39 / 123
Advertisement
Table of Contents
