EBS CPX220NWB Installation And Programming Manual page 112

9.1.3.5. CPADDUSER
Format:
Limitations:
Description
9.1.3.6. CPDELUSER
Format:
Limitations:
CPX220NWB ALARM CONTROL UNIT – INSTALLER MANUAL
CPADDUSER=id,partitions,password[,adminPassword]
This command only works when sent through an encrypted way, you must
know the administrator password (the user id == 0), id ranging from 1 to
8 inclusive. The command needs the option"Allow remote user
management" to be set to active in the Configurator. Can be executed only
by ATS or administrator. If the command is executed by ATS, specify
adminPassword
Adds a new user. Id is the user number, partitions are the partitions to
which the user will have the authorization – bit 0 corresponds to the
partition 1, bit 1 to the partition 2 , password is the password of newly
created user and adminPassword is the the system administrator
password. The command returns:
CPADDUSER:EOK,id,partitions
When a user is added
CPADDUSER:EALREADY_EXISTS,id,partitions
If the specified user already exists
CPADDUSER:EID,id,partitions
If the specified user ID is incorrect
CPADDUSER:EPERMISIONS,id,partitions
If you can not create a user because the password is incorrect
(administrator or user)
CPADDUSER:ELENGTH,id
If the new password is too short or too long or does not consist of digits
CPADDUSER:ENOT_ALLOWED
If the command is sent via open SMS or the configuration does not allow
remote management of users
CPADDUSER:EFORMAT
If the format of the sent command is incorrect
CPDELUSER=id[,adminPassword]
This command only works when sent through an encrypted way, you must
know the administrator password (the user id == 0), id ranging from 1 to
8 inclusive. The command needs the option"Allow remote user
management" to be set active in the Configurator. Can be executed only
by ATS or administrator. If the command is executed by ATS, specify
adminPassword
112 / 123