Table of Contents
Advertisement
4.1. ACTIVATION OF SERVICE MODE
To activate the service mode the installer code authorization is required.
3 beeps will confirm the correct input of the code and function number. PROG LED on will
inform that currently, the user is in service mode. When any service function is entered,
PROG LED will be blinking. After exit from the function, PROG LED will be lit constantly
again, informing that the user is in the main service mode menu.
4.2. EXIT FROM SERVICE MODE
To exit the service mode press
the control unit's reset using configured parameters.
The device will exit test mode automatically after 5 minutes without pressing the buttons
and system will restart.
4.3. INSTALLER MENU
After enter the service mode You get permision to configure alarm central. By this
commands You can get into some menu sections (more information about procedures You
will get in chapters bellow):
<XX> <Y>
<XX> <Y>
<XX> <Y>
<XX> <Y>
CPX220NWB ALARM CONTROL UNIT – INSTALLER MANUAL
Entered digit
0
1 2 3 4 5 6 7 8
1
1
2 3 4 5 6 7 8
2
1
2
3
1 2
4
1 2 3
5
1 2 3 4
6
1 2 3 4 5
7
1 2 3 4 5 6
8
1 2 3 4 5 6 7
9
1
2 3 4 5 6 7
<Installer code>
and confirm with
Instaler code change
Power loss time raport
Reset to default settings
System options
Users remote manager
Zones configuration
Outputs configuration
Partitions configuration
Wireless zones configuration
LEDs on
3 4 5 6 7 8
3
4 5 6 7 8
4
5 6 7 8
5
6 7 8
6
7 8
7
8
8
8
. Using that function will trigger
30 / 123
Advertisement
Table of Contents
