Table of Contents
Advertisement
6.1.3.5. Sequence of connections with servers
If you check this box, the equipment will try to establish a connection with primary
server, irrespectively of the secondary server parameters set (in particular, the
number of connection attempts).
6.1.4.
Secondary Server Parameters
6.1.4.1. Server IP Address
It is the IP address of a secondary (redundant) monitoring system receiver
(OSM.2007) or a computer on which "Communication server" software is installed,
e.g. 89.130.125.82. The address can be given as a server's domain name, e.g.
monitor.gprs.com. In such a case at least one DNS server address is required.
6.1.4.2. Server port
It defines a port which was dedicated in the server for the receipt of data from the
equipment.
6.1.4.3. Interval between subsequent attempts
If the equipment cannot connect with primary server, after the defined number of
attempts it will initiate the procedure of connecting with a secondary server. Here you
can define an interval (in seconds) after which the equipment will retry to connect
with a server, in case the previous attempt was unsuccessful.
6.1.4.4. Number of attempts of establishing connection with a server
You can define how many times the equipment will try to connect with a secondary
server. In case of subsequent unsuccessful attempts, after the defined number of
attempts is executed, the equipment will return to the procedure of connecting to
primary server.
6.1.4.5. Time for disconnection
If you check this box, the equipment will disconnect the secondary server after a
defined time. The following operation depends on the Connection sequence
parameter (refer to 7.1.3.5). If the option is active the equipment will try to connect
to primary server. In case the option is inactive, the equipment will complete the
procedure of connecting to secondary server first, and in case it is unsuccessful, it will
move on to attempting the connection with primary server.
6.1.5.
Access
6.1.5.1. Service code
It secures the equipment against unauthorized access. It is used for both, equipment
programming and for its remote control (in TCP/IP or SMS mode). Default factory
setting is 0000. It should be changed at first equipment start-up (programming). The
code can be composed of from four to seven digits.
CPX220NWB ALARM CONTROL UNIT – INSTALLER MANUAL
63 / 123
Advertisement
Table of Contents
