Remote Controllers Configuration - EBS CPX200NWB Installation And Programming Manual

Alarm control unit
Table of Contents

Advertisement

8 LEDs – 100% signal strength
At the same time, the keypad indicate the signal strength by a sound. 1 beep means 25%
signal strength, 2 beeps means 50% signal strength, 3 beeps means 75% signal strength, 4
beeps means 100% signal strength.
To return to line selecting menu press
To exit the function press
4.3.9.3. Delete all wireless sensors
To remove all wireless sensors from the system, enter the following function:
After entering the function PROG LED is blinking, the other LEDs are off. Pressing
deletes all wireless sensors, generating 3 beeps and exit the function. If you press
will exit the function and detectors will not be erased.

4.3.10. Remote controllers configuration

4.3.10.1. Remote controllers configuration
Remote controllers can be configured using complex service functions, after activation of
which, all the parameters related to the relevant remote control can be given subsequently
or in a form of series of service functions that configure one remote control related
parameter. Codes of the remote control configuration functions are defined as per the
following pattern:
Where:
XX – determines the number of remote control
Y – number of parameter related to a given remote control:
 0 – complex function, the initiation of which configures the parameters listed below
as set of parameters:
 1 – Delete a remote control. After selecting this option, you can confirm deleting by
pressing
 2 – Add a remote control. After selecting this option, any key on the remote control
has to be pressed. Once the transmission with the remote control is established serial
number will be displayed on the keypad (hexadecimal value). If accepted, the remote
control will be saved.
3 – type of the remote control (read only)
o 0 – no remote control
o 1 – P300 remote control
o 2 – RC-10 remote control
4 – The use to which the remote control is assigned
5, 6, 7, 8 – buttons functions:
CPX200NWB ALARM CONTROL UNIT – INSTALLER MANUAL
(or
, if no key has been selected).
<XX> <Y>
key, or you can cancel function by pressing
or
.
key
key
key.
33 / 118

Advertisement

Table of Contents
loading

Table of Contents