Table of Contents
Advertisement
<XX> <Y>
<XX> <Y>
4.3.1.
Installer code
The installer code can be changed here. 3 beeps will confirm the successfully entered
function.
where:
Installer code –
You can press
4.3.2.
Power loss
The function determines time in seconds after which failure is to be reported. The function's
argument is of decimal type. 3 beeps will confirm the successfully entered function.
To change /configure the time:
where:
Time –
time in seconds
You can press
4.3.3.
Reset to default settings
That function resets the settings to their default configuration, accessible from the service
mode level. Additionally, the function sets the default output options and default installer
code. The wireless detectors and remote controls are not deleted.
In order to protect the settings against accidental modification, the function is to be
confirmed with installer code. 3 beeps will confirm the successfully entered function. Using
that function will trigger the control unit's reset using default parameters.
You can press
4.3.4.
System options
That function allow to switch on and switch off additional options of the system. The
argument of the function is BIT type. By pressing 1, 2, 3, 4, 5 and 6 keys, you can switch
on/off proper option. 3 beeps will confirm the successfully entered function.
Where:
Options – number of option (BIT type parameter):
CPX220NWB ALARM CONTROL UNIT – INSTALLER MANUAL
<Installer code>
new installer code (from 4 to 7 digits)
any time to exit without saving changes.
any time to exit without saving changes.
any time to exit without saving changes.
Remote controllers configuration
Emergency buttons
<Installer code>
<Time>
<Installer code>
<Options>
31 / 123
Advertisement
Table of Contents
