Download Setup Data To Drive/Motor; Changing The Drive Axis Id; Evaluate Drive/Motor Behaviour (Optional) - Technosoft IPS110 Technical Reference

Intelligent stepper. minidrive for step and brushed dc motors

Table of Contents

4.2.3. Download setup data to drive/motor

Press the Download to Drive/Motor button

drive/motor EEPROM memory in the setup table. From now on, at each power-on, the setup data

is copied into the drive/motor RAM memory which is used during runtime. It is also possible to

the setup data on your PC and use it in other applications.

Save

To summarize, you can define or change the setup data in the following ways:

• create a new setup data by going through the motor and drive dialogues

• use setup data previously saved in the PC

• upload setup data from a drive/motor EEPROM memory

You can use the Data Logger or the Control Panel evaluation tools to quickly measure and

analyze your application behavior. In case of errors like protections triggered, use the Drive

Status control panel to find the cause.

The axis ID of an IPS110 drive can be set in 2 ways:

Hardware (H/W) – according with the solder joints configuration in the range 1 to 31 or

255 (see 3.3 Jumper and solder joint configuration)

Software – any value between 1 and 255, stored in the setup table

The axis ID is initialized at power on, using the following algorithm:

a) If a valid setup table exists, with the value read from it. This value can be an axis number

1 to 255 or can indicate that axis ID will be set according with DIP switch selection

b) If the setup table is invalid, with the last value set with a valid setup table. This value can

be an axis number 1 to 255 or can indicate that axis ID will be set according with DIP

switch selection

c) If there is no axis ID set by a valid setup table, according with the solder joints

configuration

Remark: If a drive axis ID was previously set by software and its value is not anymore known,

you can find it by selecting in the Communication | Setup dialogue at "Axis ID of drive/motor

connected to PC" the option Autodetected. Apply this solution only if this drive is connected

to download your setup data in the

IPS110 Technical Reference

Table of Contents