Jumper And Solder Joints Configuration - Technosoft IPS110 Technical Reference

3.3. Jumper and solder joints configuration

JP1: Auto / Ext
o
•
•
JP2: FU / Norm
o
•
•
ID5...ID0: Axis ID solder-joints
o
These solder-joints are sampled during power-up, and the Axis ID is configured
accordingly. See Table 3.1.
ID5 ID4
OPEN OPEN
OPEN OPEN
OPEN OPEN
OPEN OPEN
© Technosoft 2007
Figure 3.18. Jumpers (JP1 and JP2) and solder joints
SHORT:
automatically executes a program from the internal E
OPEN:
for commands from an external device.
SHORT: Enable firmware update
OPEN: Normal operation
Table 3.1. Axis ID configuration
Axis ID solder-joints
ID3
OPEN OPEN
OPEN OPEN
OPEN OPEN
OPEN OPEN
IPS110 in Autorun (stand-alone) mode. After reset,
IPS110 in External (slave) mode. After reset, waits
ID2 ID1
OPEN OPEN
OPEN SHORT
SHORT OPEN
SHORT SHORT
32
2
ROM.
ID0 Axis ID
255
62
61
60
IPS110 Technical Reference