Table of Contents
Advertisement
Operating and Maintenance Manual
15.7.6
Winding the cable with the ROLL OUT remote control
NOTICE
In order for the ROLL OUT remote control to work, you must observe the following points:
►
The remote control must be switched on.
►
"Unwinding the cable" must have been activated.
►
At least one of the cab doors must be opened.
■
Unwind the cable with the ROLL OUT remote control
1.
Drive the snow groomer approx. 10 m (32 ft) from the anchoring point.
2.
Engage the snow groomer's parking brake.
3.
Make sure the winch arm is tilted up.
4.
Swivel the winch arm so it points to the anchoring point by pushing the mini-joystick to the left
or right.
5.
Press the push-button switch for unwinding the cable <A37/6>.
6.
The cable is slackened and the front cable guide is lowered.
7.
Climb out of the driver's cab with the ROLL OUT remote control and leave the driver's cab
door open.
8.
Unhook the anchoring hook on the winch arm and automatically unwind the cable by pressing
the R0-2 button on the ROLL OUT remote control.
9.
As it unwinds, the cable is fixed to the anchoring hook and guided to the mount point on the
anchorage. Once it has reached the desired length, release the R0-2 button to stop unwinding.
10.
Attach the cable and secure it with the locking lever.
■
Rewind the cable with the ROLL OUT remote control
1.
Drive the snow groomer approx. 10 m (32 ft) from the anchoring point.
2.
Press push-button switch <A37/7> to disable the winch operation mode.
3.
Engage the snow groomer's parking brake.
4.
Press the push-button switch for unwinding the cable <A37/6> until the cable is so slack that it
can be detached from the anchoring point without pulling it taut.
5.
Climb out of the driver's cab with the ROLL OUT remote control and leave the driver's cab
door open.
6.
Detach the cable from the anchoring point.
7.
Press the R0-3 button on the ROLL OUT remote control to automatically rewind the cable. Au-
tomatic rewinding is indicated by a warning lamp on the winch arm. As it rewinds, the cable is
fixed to the anchoring hook and guided to the mount point on the winch arm.
8.
If approx. 2 m (6 ft) of cable are still available, release the R0-3 button to stop rewinding.
9.
Attach the anchoring hook to the winch arm.
10.
Press push-button switch <A37/12> to rewind the last meters of cable. The remaining cable is
then rewound.
15.7.7
Rewind the last few meters of cable
Prerequisites
■
For the function "Rewind the last few meters of cable", both doors must be closed.
230
(255)
15 - AUTOMATIC Winch
Snow groomer BISON
BISON 908930245 - 30367
Advertisement
Table of Contents
