Snow groomer BISON
■
Once the bowl is full, hold the switch for 30 s to fill the other filters and lines (fuel pressure can be
seen on the display in the cab, pressure must raise to 2 bar minimum otherwise there is still air
bubbles in the system);
■
Wait one minute and hold the switch a second time for 30 s;
■
Wait one minute and hold the switch a third time for 30 s;
■
Start the diesel engine.
When starting, do not crank for more than 20 s as this could cause permanent damage to engine com-
ponents.
If the engine fails to start, wait two minutes before cranking again. Before making an other try, investi-
gate for a possible problem. Check the display in the cab to see if a diagnostic or event code helps to
pinpoint the problem.
When the system is properly purged, the fuel pressure should reach 2 bar within 5 s of the switch acti-
vation. If it takes 10 s or more, air could still be trapped in the system.
11.14
Wheels
11.14.1
Check tension wheels, running wheels and sprocket wheels
Pos. Name
1
2
3
NOTICE
►
Check wheel nuts after the first 40 operating hours and tighten if required.
■
Check the tension wheels (1) and running wheels (2)
□
□
□
BISON 908930245 - 30367
1
2
Figure 109: Tension wheels, running wheels and sprocket wheels
Tension wheels mounting torque : 340 Nm (250 ft-lb)
Running wheels mounting torque : 230 Nm (170 ft-lb)
Drive sprockets mounting torque : 145 Nm (107 ft-lb)
Check tightening torque of the mounting nuts.
Carry out visual check of tyres and wheel rims.
Check tire walls for damage.
Operating and Maintenance Manual
11 - Maintenance
3
185
(255)