Verification Of The Cab Locking Pins; Lubrication Points - Prinoth BISON Operating And Maintenance Manual

Snow groomer BISON
11.5

Verification of the cab locking pins

Pos. Name
1
When the cab is raised for maintenance, ensure the pins at the back of the cab can rotate freely. Jam-
med pins could cause premature wear of the cab locking system.
11.6

Lubrication points

NOTICE
Risk of damage to property
Failure to observe the lubrication intervals or to use the approved lubricants may cause damage to
property.
► Observe the specified lubrication intervals
► Clean lubricating fittings before lubricating
► Replace damaged lubricating fittings immediately
■ The required lubrication intervals are indicated on the maintenance schedule. Grease the lubrica-
tion points indicated with arrows on the following drawings, as well as the hydraulic cylinders for
tilting the cab and load platform.
■ Before lubricating, thoroughly clean the lubricating fittings in order to prevent dirt or foreign matter
from entering.
■ Damaged lubricating fittings are to be replaced immediately. Press the specified lubricating
grease through the fitting until all the old grease has been evacuated.
BISON 908930245 - 30367
Figure 92: Cab locking hardware
Cab locking pins (qty 2)
Operating and Maintenance Manual
1
11 - Maintenance 155
(255)