Table of Contents
Advertisement
Operating and Maintenance Manual
15.
Tighten the front fitting of the AUTOMATIC
winch and snow groomer (11) using a
tightening torque of 120 Nm.
16.
Tighten the rear fitting of the AUTOMATIC
winch and snow groomer (12) using a
tightening torque of 135 Nm.
17.
Insert hydraulic cylinder (8) using the hydraulic pump.
18.
Insert bolt and secure with nut (9).
19.
Clean the fittings.
20.
Connect the hydraulic hoses according to their numbering.
21.
Connect the electrical wiring.
22.
Tighten the quick-connect couplings of the hydraulic hoses using a spanner (10 Nm and
20 Nm).
23.
Make sure the hydraulic hoses are correctly routed.
24.
Check the hydraulic hoses and bolt fittings for leaktightness; correct any oil leaks immediately.
25.
Remove the driver's cab safety strut (10).
26.
Lower and lock driver's cab.
27.
Carry out the specified checks before putting the AUTOMATIC winch back into service.
15.6.3
Removing the winch
WARNING
Risk of accident
If not mounted properly, the AUTOMATIC winch may come loose and fall off, causing injuries.
►
Check the condition and load capacity of the AUTOMATIC winch's lifting hook and ensure it is
correctly inserted.
►
Make sure the locking lever on the lifting hook is closed.
►
Exercise utmost caution when working with suspended loads.
1.
Move the snow groomer to a suitable place for removing the AUTOMATIC winch.
2.
Swing the winch arm toward the rear of vehicle.
222
(255)
15 - AUTOMATIC Winch
Snow groomer BISON
BISON 908930245 - 30367
Advertisement
Table of Contents
