Controlling Rear Attachments - Prinoth BISON Operating And Maintenance Manual

Operating and Maintenance Manual
■
Risk of projection
There is a risk that stones and/or other objects under the snow can be thrown up into the air,
and these could cause physical injury to people and/or damage to property.
►
NOTICE
Correct operation
►
►
The snow plough can be used only if the snow groomer standby is activated. If the snow
groomer is fitted with a snow plough, the push-button A36/17 is used to switch between the
plough and the rear tiller.
■ A snow plough cannot be used at the same time as the rear tiller. If the snow plough is used at
increased engine speed (approx. 1600 rpm) and low vehicle speed, adjust rotary control P.
➽ See "Joystick" (p. 60)
■ Front bucket loader (optional)
■ When the front blade is mounted, a bucket can be used to load and relocate snow. With the
bucket open, compact the snow with the front blade, then close the bucket. When loading
snow, the front blade must be raised along with the bucket.
8.10

Controlling rear attachments

WARNING
Risk of accident
If any people or obstacles are located in the work area around the rear tiller, this can result in a seri-
ous accident.
► Take particular care to ensure that no persons or obstacles are present in the work area around
the rear tiller.
■ Operating the rear tiller
The cutter shaft stops automatically when one of the following functions is selected:
■ Rear attachment raised
■ Reverse Motion
■ Switching off the operational readiness of the attachments
■ The rear articulated arm and rear tiller are moved using the joystick.
□
□
□
120
(255)
WARNING
Make sure that no one is standing within a radius of at least 50 m (164 ft) around the
snow plough while the engine is running.
In case of strong, steady winds, it is advisable to only plough the snow in such a way that
it is not directed against the wind.
Drive at low speed when changing locations (e.g. from garage to work area), as the snow
plough is heavier than the front blade.
➽ See "Keyboard 1" (p. 56)
Used along with the push-button switches on the joystick, all the available attachment
functions of the rear attachment can be performed with one hand. The individual func-
tions of each of the push-button switches depend on the type of equipment and can
therefore vary.
When the rear attachment is raised, it automatically moves into centred position.
When reversing, the rear attachment is raised and centred automatically, and the tiller
shafts are stopped.
8 - Driving
Snow groomer BISON
➽ See "Joystick" (p. 60)
BISON 908930245 - 30367